TD-1-TS Tension Indicator
Accurately displays tension values calibrated in any unit of measure on a bright LED display, designed for flush panel mounting.
Calibration and alarm settings are adjusted using screw potentiometers located behind the removable front panel.
- Designed for use with the TS621 Strain Gauge Amplifier or the RFSE Tension Sensor
- Provides 24 VDC power for TS621 or RFSE
- User-set High & Low Alarm Limits with relays
- 4-20 mA and 0-10 VDC analog output (user set)
RFS On-Line Tension Sensor
- Resolution of 0.1% and better
- Rugged stainless steel housing is environmentally sealed
- Overload protection up to 800%
More details
TS621 Strain Gauge Amplifier
- Designed for use with a wide range of strain-gauge-based force, load and tension sensors
- 0-10VDC analog output
More details
| Display Range | 0- 1999 (calibrated for any units) |
| Display | 3 1 /2 - digit Red LED, 14.4 mm high |
| Decimal Point | User-selected via internal jumper |
| Power Supply | 24 VDC @ 100mA |
| Analog Output | 4-20 mA or 0-10 VDC, user selected |
| Frequency Response | 1 Hz (with damping filter) 40 Hz (without damping filter) |
| Enclosure Material | High-Impact Plastic |
| Dimensions | 3.78" W x 1.89" H x 4.04" D (96 x 48 x 103mm) |
| Panel Cutout | 92 x 44 mm |
| Operating Temperature | 32 to 122° F (0-50°C) |
| Relay Operation | Hi-Hi/Hi or Hi-Lo |
| Relay Rating | 1 Amp @ 250 VAC/ 30 VDC, normally open |
| Power Required | 115/ 230 VAC + 10%, 50/ 60 Hz |